Back to all

Automotive Tips from Tuffy Fort Wayne - Dupont Rd.: Serpentine Belt System Wear

July 11, 2021

The primary job of the serpentine belt for Fort Wayne drivers is to provide important traction to spin the accessories. As the belt wears it loses some of its grip and the accessories may not spin at optimal speeds. For example, if your alternator doesn’t spin fast enough, the battery will not completely recharge while you’re driving and you could end up stranded around Fort Wayne with a dead battery.

In short, a worn serpentine belt will stress all of the accessories it powers leading to premature wear and possible early replacement. When as little as 5% of belt material is lost, the serpentine belt cannot provide the proper traction for the accessories. Your friendly and professional Tuffy Fort Wayne - Dupont Rd. service advisor can inspect your belt for excessive wear and replace your serpentine belt system if it’s excessively worn.

Give us a call.

Tuffy Fort Wayne - Dupont Rd.
1910 W. Dupont Rd.
Fort Wayne, IN 46818
260.489.4800

More articles from Tuffy Fort Wayne (Dupont Rd.)

Mercury Rising (Hot Weather Vehicle Concerns)

July 27, 2025

The heat is on, and your vehicle takes a beating when it is. Several of your vehicle's systems are under extra stress in hot weather, so here are a few to make sure are getting the care and maintenance they need. It makes sense that the cooling system is one to make sure is in top shape. Vehicl... More

When Your Tires are Tired (Tire Replacement)

July 20, 2025

Tires are so reliable these days that few drivers pay much attention to them. But tires wear out. They have a tough job since they are the only point of contact between your vehicle and the road. They have to get your vehicle going from a stop, keep it going, make sure it is headed in the dire... More

Flat Tire? Three?s the Charm (Tire Repair)

July 13, 2025

For most drivers, at some point youre going to have a flat tire. Depending on how it was damaged, it may have to be replaced. But sometimes, a repair will do the trick, as long as the puncture isnt on the sidewall and the hole is smaller than inch/6.35mm in diameter. Here are the three common w... More